Quickly and easily remove the floor plate from your Glock magazine.
Machined from polymer to provide a robust tool for years of service.

Usage Instructions:

• Slide magazine with rear facing down into the appropriate slot in tool.
• Insert pin punch in properly labeled hole from back side into the magazine.
• Push magazine down into tool until it hits the shelf.
• Remove punch and magazine from tool and carefully slide baseplate the rest of the way off magazine (caution: items under spring pressure, wear protective eye wear).

Fits the following make and models:

• Glock 9/40/357/45Gap , 10/45, and .380 magazines.
• Springfield 40S&W
• Walther P22
• ISSC M22
• RIA 1911 high cap (22TCM/9mm)
• S&W M&P
• S&W SD9VE
• Keltec's

Pin Punch not included.